2015 Ford F-350 SD

Defect. Ford Motor Company (Ford) is recalling certain 2015-2019 Lincoln MKC, Mustang, F-350 SD, F-250 SD, F-450 SD, 2015-2017 Lincoln Navigator, Expedition, 2015-2018 Edge, Transit Connect, 2016-2019 F-550 SD, Transit, 2017-2019 Econoline, and 2019 Ranger vehicles. The rearview camera may display a distorted, inverted, or blank image when the vehicle is in reverse.

Risk. A rearview camera that displays an inverted, distorted, or blank image can reduce the driver’s view behind the vehicle, increasing the risk of a crash.

Remedy. Dealers will inspect and replace the rearview camera as necessary, free of charge. Owner notification letters were mailed January 13, 2026. Ford owners will receive letters in phases, beginning January 2026 and June 2026. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 25S89. This recall expands previous NHTSA recall number 25V270. Vehicle Identification Numbers (VINs) involved in this recall will be searchable on NHTSA.gov beginning September 8, 2025.

Defect. Icon Vehicle Dynamics, LLC (Icon) is recalling all 05-UP FSD 2.5 Centerline Stabilizer Kits with part number 65050. The kits were sold as an accessory for certain 2005-2021 Ford F-250 4X4 and F-350 4X4 pickup trucks. The foam ring inside the stabilizer "through shaft" may block the piston ports, possibly causing the steering to lock up.

Risk. If the steering locks, it can increase the risk of a crash.

Remedy. Icon will notify owners, and dealers will install a new shock assembly with a revised foam ring and steel support disc, free of charge. The recall began December 21, 2020. Owners may contact Icon customer service at 1-951-689-4266.

Defect. Ford Motor Company (Ford) is recalling certain model year 2011-2015 Ford F-350, F-450, and F-550 trucks manufactured February 22, 2010, to January 30, 2015, and equipped with ambulance or fire engine preparation packages. The affected vehicles may detect an incorrect Exhaust Gas Temperature Sensor (EGT) fault indicating that the vehicle is too hot, causing the engine management system to shut down the engine and prevent its immediate restart.

Risk. Engine shut down and a subsequent cool down period may delay medical treatment or assistance to those needing it, increasing their risk of injury.

Remedy. Ford will notify owners, and dealers will update the Powertrain Control Module (PCM) software, free of charge. The recall began on April 22, 2015. Owners may contact Ford customer service at 1-866-436-7332. Ford's number for this recall is 15S09.

Defect. Ford Motor Company (Ford) is recalling certain model year 2015 F-250, F-350, F-450, and F-550 Super Duty trucks manufactured September 13, 2013, through March 28, 2014, and equipped with 6.2L gasoline or 6.7L diesel engines and 6R140 transmissions. An error with the transmission control software may be such that while shifting from "Park" to "Drive" the vehicle may display "Drive" but possibly engage "Reverse" for 1.5 seconds before engaging "Drive." Therefore, the vehicles do not conform to Federal Motor Vehicle Safety Standard (FMVSS) number 102, "Transmission Shift Lever Sequence, Starter Interlock, and Transmission Braking Effect."

Risk. If the vehicle is in "Reverse" while the while the gear selection shows "Drive," unexpected movement could occur, increasing the risk of a crash.

Remedy. Ford will notify owners, and dealers will update the transmission software, free of charge. The recall began on May 6, 2014. Owners may contact Fords customer service at 1-800-392-3673. Ford's number for this recall is 14C04.

On June 9, 2026, the vehicle received a PCM reprogramming under Ford Recall 21E01. Before the update, the transmission had no symptoms: no slipping, no warning lights, and no diagnostic trouble codes. Between June 9 and August 11, the vehicle accumulated 1,894 miles. On August 11, 2026, while driving about 60 mph, the vehicle suddenly downshifted from sixth to fifth gear without input. A clunk was felt, followed by complete loss of all gears. There were no warning lights, no diagnostic trouble codes, and no limp‑mode activation. The failure was sudden and total. A diesel shop retrieved the strategy values after the incident, which showed no recorded indication of transmission degradation prior to the PCM update. The failure occurred less than 2,000 miles after the PCM reprogramming. The vehicle was in factory‑stock condition. The incident raises concern that the updated PCM calibration may have affected torque calculation, shift coordination, or diagnostic monitoring, resulting in an uncommanded downshift and loss of all gears without protective response.

See attached document for complaint.

The contact owns a 2015 Ford F-350. The contact stated that the camera was inoperable. At times the camera was blank. No warning lights were illuminated. The contact received the recall notification letter 25V572000 (Back Over Prevention). The vehicle was taken to the local dealer, who confirmed the parts were not available. The vehicle was not diagnosed or repaired. The manufacturer was called, but there was no response. The failure mileage was approximately 50,000.

The contact owns a 2015 Ford F-350. The contact stated that a certified mechanic had installed a disaster kit on the vehicle to prevent a fuel system failure. The independent mechanic later found metal shavings inside the filter going into the manifold. The independent mechanic recommended that the fuel pump be replaced. The contact was concerned that the replacement of the fuel pump with the same part would be a temporary fix. The vehicle was not yet repaired. The dealer was contacted and advised the contact to take the vehicle in for a diagnostic test. The manufacturer was not contacted. The failure mileage was approximately 81,000.

The contact owns a 2015 Ford F-350. The contact stated that while in reverse(R), the rearview camera displays a blue screen or a blank screen while in reverse. The contact then received notification of NHTSA Campaign Number: 25V572000(Back Over Prevention); however, the part to do the recall repair was not yet available. The dealer was notified of the failure and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time to repair the recall. The manufacturer was notified of the failure and gave the contact the same information as the dealer. The vehicle was not repaired. The failure mileage was approximately 55,000.

Odometer Fraud. The contact's spouse recently sold a 2015 Ford F-350; however, the spouse still had the vehicle in possession. The contact discovered that there was a mileage discrepancy after viewing the post online. The vehicle was a private sale. At the time of the sale, the mileage was 650,000. Upon checking Facebook Marketplace, the mileage was 120,000.

The contact owns a 2015 Ford F-350. The contact stated that the rearview camera displayed a black image while in reverse(R). The vehicle was taken to the dealer, where two modules were replaced, and the new modules were reprogrammed at the contact's expense; however, the failure reoccurred approximately two months later. The contact later received notification of NHTSA Campaign Number: 25V270000 (Back Over Prevention), and the vehicle was taken to the dealer, where the recall repair was completed. The contact requested reimbursement from the manufacturer and sent supporting documents; however, the manufacturer denied reimbursement because the vehicle was previously repaired due to a rearview camera black image while the recall pertained to a blank image. The failure mileage was approximately 35,576.

What component or system failed? The Steering and Suspension system failed. Specifically, the front axle hubs, track bar, and U-joints failed, causing a violent loss of steering control known as "Death Wobble." These components are currently available for inspection; however, they were diagnosed as "FAILED" and requiring immediate replacement to make the vehicle safe to drive. How was safety put at risk? The failure caused violent, uncontrollable shaking of the steering wheel and front end at highway speeds. This resulted in a near-total loss of directional control, putting the driver and surrounding traffic at immediate risk of a collision. The defect made the vehicle impossible to steer safely above 45 MPH. Has the problem been confirmed? Yes. The failure was reproduced and confirmed by an independent certified service center, AutoNation Ford Gulf Freeway. Their inspection explicitly diagnosed the front axle hubs, track bar, and U-joints as "FAILED" and unsafe. The repair estimate to correct these safety defects totaled $6,128.09. Has the vehicle been inspected? Yes. It was inspected by AutoNation Ford Gulf Freeway (a certified Ford dealership) immediately following the incident. Were there warning symptoms? The symptoms (violent wobble) appeared immediately after purchasing the vehicle. During the pre-purchase test drive, the selling dealer's agent physically manipulated the steering wheel ("pulled the wheel") to prevent the wobble from occurring, concealing the pre-existi

My truck is been having a death wobble for years now. It's scary, I changed tires suspension and I still have the issue.

The touch screen interface is misaligned and occasionally not working at all. The misalignment means that to activate a button the driver must click somewhere else in the screen than the location where the button is displayed. This offset appears to change infrequently. This cause the driver to have to hunt for the location where the button responds and not pay attention to the road. If the wrong location is touched it may open random menus or start unintended functions, causing additional distractions and requiring multiple screen interactions. The car does not have physical buttons for most functions. On several occasions I found myself drifting out of lane due to this problem.

The contact owns a 2015 Ford F-350. The contact stated that while reversing, the back-over prevention camera went blank off and on. In addition, the contact stated that occasionally, the back over prevention screen displayed a foggy image. The contact received notification of NHTSA Campaign Number: 25V270000 (Back Over Prevention). The vehicle was taken to the dealer; however, the vehicle was not inspected. The contact was informed that an appointment was required and that the vehicle needed to be inspected to confirm the failure. The contact was informed that if the failure was confirmed, the parts would be ordered for the repair to be performed. The contact stated that the recall notification indicated that the back over prevention camera was on recall and needed to be replaced. The vehicle was not diagnosed or repaired by an independent mechanic or the dealer. The manufacturer was not made aware of the failure. The failure mileage was unknown.

The contact owns a 2015 Ford F-350. The contact received notification of NHTSA Campaign Number: 25V270000 (BACK OVER PREVENTION). However, the part to do the recall repair was not yet available. The contact stated that the rearview camera displayed a black screen while the vehicle was in reverse(R). The contact stated that the failure obstructed the driver's visibility, which prevented the driver from safely operating the vehicle. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The approximate failure mileage was 100,000.

The contact owns a 2015 Ford F-350. The contact received notification of NHTSA Campaign Number: 25V270000 (BACK OVER PREVENTION); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure.

The contact owns a 2015 Ford F-350. The contact stated that while driving at an undisclosed speed, the contact became aware that the electronic power steering was not functioning properly, requiring the steering wheel to be manually returned to center after completing a turn. The vehicle returned to normal functionality, but the failure became a regular occurrence. No warning lights were illuminated. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 120,000.

The contact owns a 2015 Ford F-350. The contact received notification of NHTSA Campaign Number: 25V270000 (BACK OVER PREVENTION); however, the part to do the recall repair was not yet available. The contact stated that the rearview camera displayed a black screen while the vehicle was in reverse(R). The contact stated that the failure obstructed the driver's visibility, preventing the driver from safely operating the vehicle. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 70,000. VIN tool confirms parts not available.

2015 Ford F350 6.7 liter Diesel Turbocharger with only 58,000 miles malfunctioned while accelerating on to freeway without any prior warning indicators or symptoms. Immediately engine acceleration was reduced drastically causing freeway cars to nearly rear end my vehicle and other cars swerving to avoid accident. A message showed up simultaneously while reduced acceleration occured on vehicle’s dash display indicating something to the effect “Reducing Acceleration” and a yellow check engine icon lit up on dash display. I limped the vehicle to the side of Freeway and shut engine off. Upon restarting engine discovered engine and turbo operated properly and was able to drive vehicle to a non-Ford Service Center to be repaired. The Technician could not find anything wrong with the operation of the engine-turbocharger and cleared the trouble code. Drove vehical for approximately 500 miles and the same reduced acceleration problem re-occurred while accelerating on to freeway. Pulled vehicle over to safe area, shut engine off, re-started engine, engine and turbocharger operated properly, drove home and then to Ford Dealership (check engine icon still lit). Discovered vehicle can not be smog tested with this intermittent problem due to check engine icon. My safety, my passengers safety, and others safety while driving on the freeway were put at high risk. The reduced acceleration problem does reoccur. Ford diagnosed the vehicle problem to be a bad turbo with an estimate of $5,100 dol

The contact owns a 2015 Ford F-350. The contact received notification of NHTSA Campaign Number: 25V270000 (BACK OVER PREVENTION); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2015 Ford F-350. The contact stated that while in reverse, the back over prevention camera displayed a solid black or blue screen, or a severely distorted image. Additionally, the message "Camera Unavailable - Please Contact Your Dealer" was displayed. The contact stated that the failure was intermittent. The cause of the failure was not yet determined. The manufacturer and local dealer were notified of the failure, but no assistance was offered. The contact was informed that the VIN was not included in the NHTSA Campaign Number: 25V270000 (BACK OVER PREVENTION). The contact stated that the vehicle had experienced the failure listed in the recall. The failure mileage was 78,000.

The contact's wife owns a 2015 Ford F-350. The contact received notification of NHTSA Campaign Number: 25V270000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that while reversing, the rearview camera image was intermittently distorted or blank. Additionally, the messages “Camera Unavailable” and to “Contact Dealer” were displayed. The local dealer was contacted. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 186,000. VIN tool confirms parts not available.

Rear Camera intermittent failure. I was just notified of the recall, but I'm experiencing the issue. Ford doesn't want to authorize the repair under the recall, even though they sent the notice, and I'm having the problem.