2014 Toyota Prius

Defect. Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2013-2015 Prius and 2014-2017 Prius V vehicles not included in recall 18V-684. Excessive voltage in the Intelligent Power Module (IPM) within the inverter may cause the hybrid system to shut down, causing the vehicle to stall while being driven.

Risk. An unexpected hybrid power system shut down may increase the risk of a crash.

Remedy. Toyota will notify owners, and dealers will perform a software update for the hybrid system. If the vehicle has experienced an inverter failure with certain hybrid system faults related to this condition, the inverter assembly will be repaired or replaced, prior to software update. All repairs will be performed free of charge. This recall began July 24, 2020. Owners may contact Toyota customer service at 1-888-270-9371. Toyota's number for this recall is 20TB10 / 20TA10.

Defect. Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2010-2014 Toyota Prius and 2012-2014 Toyota Prius V vehicles. Excessive voltage in the Intelligent Power Module (IPM) within the inverter may cause the hybrid system to shut down, causing the vehicle to stall while being driven.

Risk. If the hybrid system shuts down unexpectedly, it can increase the risk of a crash.

Remedy. Toyota will notify owners, and dealers will update the software for the motor/generator control electronic control unit (ECU) and the hybrid control ECU as necessary, free of charge. The recall began January 22, 2019. Owners may contact Toyota customer service at 1-888-270-9371. Toyota's number for this recall is J0V. Note: The software updates in this recall are needed even if the vehicle had the software previously updated under recalls 14V-053 or 15V-449.

Defect. Toyota is recalling certain model year 2010 through 2014 Prius vehicles. In the affected vehicles, the Intelligent Power Module (IPM) inside the inverter module (a component of the hybrid system) contains transistors that may become damaged from high operating temperatures. If this occurs, various warning lamps will be illuminated on the instrument panel and the vehicle will have reduced power allowing it to only drive a short distance.

Risk. The vehicle may enter a fail-safe/limp-home mode that limits the drivability of the vehicle. The hybrid system could also shut down completely resulting in a vehicle stall, increasing the risk of a crash.

Remedy. Toyota will notify owners and dealers will update the software for both the motor/generator control electronic control unit (ECU) and the hybrid control ECU, free of charge. If an owner experiences a failure of the inverter before the vehicle receives updated software, the dealer will repair or replace the inverter assembly with a new one at no charge. The recall began on March 21, 2014. Owners may contact Toyota at 1-800-331-4331.

ABS and brake light are on. was on the freeway and when i pressed the brake the wheels got locked and the car made a 360 spin, it almost flipped over

While driving my 2014 Toyota Prius, the BRAKE, ABS, and vehicle stability/traction control warning lights illuminated. There was no crash, injury, or noticeable loss of braking before the warnings appeared, and there were no preceding symptoms. The vehicle was evaluated by Mac Haik Toyota in League City, TX, an authorized Toyota dealer. They diagnosed DTC C1391, “Abnormal Leak of Accumulator,” and determined that the brake booster and brake booster pump/accumulator assembly require replacement. The dealer advised that the vehicle cannot be driven and is considered down. The vehicle/components are available for inspection upon request. My safety concern is that this is a brake-system malfunction serious enough that an authorized Toyota dealer has determined the vehicle cannot be driven. Toyota previously established Customer Support Program ZJB addressing internal malfunctions of the brake booster and brake booster pump assemblies in 2011–2015 Prius vehicles. Toyota’s documentation specifically identifies C1391 as a diagnostic code associated with this condition. My Prius has only approximately 102,000 miles, well below the program’s 150,000-mile limitation, but is outside its 10-year time limitation. The Toyota replacement part required to repair the brake system is now backordered with no known timeframe for availability. Because Toyota has advised the vehicle cannot be driven, it will remain out of service until the part becomes available. I am reporting this because a prev

I am submitting this complaint regarding a serious safety concern involving the brake actuator/booster assembly on my 2014 Toyota Prius. My vehicle has experienced failure of this critical braking component and has been unable to be properly repaired since November due to difficulty obtaining the correct replacement parts. This involves a major safety system required for proper braking operation. Brake actuator/booster assembly. Diagnostic codes: B1206, B2321, C1252, C1253 C1256. Toyota previously acknowledged brake actuator concerns through Customer Support Program ZJB. However, my vehicle is outside the program limits despite experiencing what appears to be the same type of failure reported by many other Prius owners. Since November, I have faced difficulty obtaining the correct parts, reports of nationwide backorders or limited availability, conflicting information regarding updated Toyota part numbers, and concerns about repair providers advertising new OEM parts that may actually be aftermarket or incorrect components. This creates a safety concern because owners experiencing brake failures may be unable to obtain timely repairs using verified, appropriate parts. Repair estimates have ranged from approximately $3,000 to over $4,000, including a Toyota dealership estimate of approximately $4,100. This creates a significant barrier to restoring a vehicle to safe operation, especially involving a component Toyota has previously addressed through a customer support program.

My car experienced a failing brake actuator/accumulator. The first sign was the ABS and break lights accompanied by a whoosing sound. The issue causes intermittent system wide break failure and renders the car undriveable. Toyota had an extended warranty for this issue but that offer was closed by the time my car had the failure even though it was still under 150,000 miles. I believe this is a significant safety issue and should rise to the level of a recall by Toyota.

Brake actuator had been making noises and it finally stopped working on 7/14/26. Thankfully my car was and stopped and parked. The car has 137k miles on it, one owner and no explanation of what caused this. There were no accidents, abuse, or failure to maintenance.

The traction control, abs, and emergency brake light came on. We checked and the code produced was C1391. There’s a humming noise every 10 or so seconds when idle. The humming noise is also present when braking. We did some research and this appears to be an issue with Toyota Prius. We called the dealership and were informed that this was not a known issue. Thank you.

Car is at less than 105k miles and yet brake actuator is failing.

ABS, traction control, brake system, and brake lights turned on while driving. Took the car to the mechanic and pulled the code C1391. It seems from other complaints to NHTSA that it is a common issue and quite dangerous, meaning the brake system is failing.

ABS, brake, and traction warning lights came on. Loss of power brakes/limited manual brake. Extended warranty/customer service outreach did not apply. Car is at 120,000 miles and almost 12 years.

When the brake is applied, the vehicle accelerates for a fraction of a second before slowing down. I have experienced this when the vehicle is moving slowly, such as in a parking lot.

On April 5, 2026, while driving downhill around a corner in my 2014 Toyota Prius, the brake booster and brake booster pump assembly failed without any prior warning. When I pressed the brake pedal the car did not slow down and instead appeared to accelerate due to a complete loss of braking assist. I was unable to stop the vehicle normally and had to rely on gravity and coasting to slow down, creating a serious risk of collision. There were no warning signs prior to the failure. Immediately after the incident, three warning lights illuminated on the dashboard: the BRAKE light, the ABS light, and the VSC (vehicle stability control) light, which have remained on since. The vehicle was taken to DARCARS Toyota Baltimore, 6007 Eastern Ave, Baltimore, MD 21224, where the failure was confirmed on April 15, 2026. Technician Victor Lawson diagnosed diagnostic trouble code C1391, which is the exact qualifying code listed under Toyota's Customer Support Program ZJB for brake booster and brake booster pump assembly failure (RO# XXX). The vehicle remains at the dealership and is available for inspection. Toyota corporate was contacted and opened case number XXX but declined to cover the repair despite this being a documented issue that Toyota has publicly acknowledged. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

While driving, three warning lights suddenly appeared on the dashboard . Abs warning, traction light, and break warning light At the same time, the brake pedal became very hard to press, and the vehicle did not slow down as expected. This caused a significant increase in stopping distance, and I nearly rear-ended the vehicle in front of me. The issue appears to involve the braking system and created an immediate safety risk. No prior warning signs were noticed before this incident. The vehicle has not yet been inspected but is available for inspection upon request.

Subject: Brake Booster/Pump Assembly Failure – Toyota Program ZJB / 23TE07 Description of Incident: I am reporting a failure of the brake booster and pump assembly on my 3rd Generation Prius (82,000 miles). While the vehicle is 11.3 years old, it is well under the 150,000-mile threshold of Toyota’s Customer Support Program ZJB. The brake pump began cycling every 13 seconds, indicating an internal pressure leak in the accumulator. This is a documented precursor to a total loss of power-assist braking. Despite the clear mechanical failure, no warning lamps or Diagnostic Trouble Codes (DTCs) were triggered, creating a safety hazard where the system could fail without prior electronic notification. Repair and Cost Details: Because the vehicle was 1.3 years past the arbitrary 10-year "Secondary Coverage" window, I was forced to pay $3,461.18 out-of-pocket for a known manufacturing defect. I would like to highlight a discrepancy in labor billing: while Toyota’s own technical bulletins (ZJB/23TE07) state the repair should take approximately 5.3 hours, the dealership charged 8.9 hours of labor for the same procedure. Safety Concern: By limiting coverage to 10 years, Toyota has left many low-mileage owners with a critical safety defect that degrades over time regardless of mileage. I request that the NHTSA transition this from a "Customer Support Program" to a formal Safety Recall to ensure all affected vehicles are repaired and owners are reimbursed, regardless of the vehicle's age.

The cylinder head gasket blew because of the poor design of the intake manifold and the EGR system. There are updated parts to fix this issue, but there was no recall. This poor design led to the vehicle having "the Death Knock." It started doing this knock on my trip driving my daughter to college. The engine could have seized in traffic on the way to [XXX] from [XXX] . No warning lights came on telling me there was an issue. The vehicle is being taken apart now to see if my connecting rods were bent from the coolant entering the combustion chamber. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2014 Toyota Prius. The contact stated that while driving at an undisclosed speed, the vehicle failed to slow down as intended with the brake pedal depressed. The ABS warning light was occasionally illuminated. The vehicle was pulled over to the shoulder of the roadway and restarted. The vehicle was taken to a local independent mechanic, where it was diagnosed, and determined that the brake master cylinder, brake booster, and brake lines needed to be replaced. The local dealer was contacted; however, the vehicle was not diagnosed or repaired. Upon further investigation, the contact related the failure to an undisclosed recall; however, the VIN was not included in the recall. The manufacturer was notified of the failure. The contact was referred to the NHTSA Hotline for assistance. The failure mileage was approximately 152,000.

Vehicle: 2014 Toyota Prius v Hybrid Mileage: 79,000 miles The vehicle experienced sudden failure of the brake booster / brake accumulator system. Multiple warning lights appeared including ABS, traction control, and the red brake warning light. Diagnostic code C1391 was retrieved. The brake pedal became soft/spongy and the electric brake pump began cycling frequently. Braking performance felt reduced and inconsistent, creating a potential safety risk. This vehicle has very low mileage (79,000 miles) and has been well maintained. The failure appears to be related to a known defect in the Prius braking system. Toyota previously issued Customer Support Program 20TE07 addressing brake booster and pump failures on 2012–2014 Prius v vehicles. Despite this known issue, the repair is not being covered and the cost quoted is several thousand dollars. A failure of the brake booster/accumulator system significantly affects braking performance and should not occur at this mileage. This appears to be a widespread issue affecting Prius vehicles and represents a potential safety defect involving the braking system.

Head gasket failure. No check, engine, light or warning. My car was very well maintained regularly. After research, I found this to be a very common problem. Yes it is available for inspection. Upon request. The problem was confirmed by chemical test, ignition vapors going into engine coolant. Other symptoms were misfiring on cylinder two and cylinder four. Severe engine knocking.

The brake booster/accumulator failed on my vehicle. This part was a common failure during the 2010-2015 production run so much so that Toyota extended coverage to replace. Mine failed recently beyond the warranty extension of 10 years/150k miles. My vehicle has only 108k miles and is 15 months beyond warranty. Toyota Corporate will not replace this vital part, despite the fact it was a defective design. I can’t drive it any longer since I don’t have the $4000 to make repair. Toyota Corporate has shown little concern despite this critical safety defect.

The slip notification, abs, and brake lights turned on while driving on the highway. The brakes then became very stiff and the vehicle did not brake as fast or as well as it normally does without the lights.

2014 Prius HB with 135k miles , onboard system warning lights for Brakes, ABS system, TPMS and Traction Ctrl all came one suddenly. Brake losing pressure while vehicle making strange noise under front driver side