2013 Winnebago Era

Defect. Winnebago Industries, Inc (Winnebago) is recalling certain 2012-2021 Era 170X vehicles. The weld nut was installed on the wrong side of the bracket where the shoulder belt attaches, reducing the retention strength of the seat belt.

Risk. In the event of a crash, the shoulder belt upper anchorage may not provide adequate protection to the passenger, increasing the risk of injury.

Remedy. Winnebago will notify owners, and dealers will coordinate the inspection of affected units and the installation of a serrated flange nut in the intended weld nut location, free of charge. The recall is expected to begin December 21, 2020. Owners may contact Winnebago Customer Care at 1-800-537-1885.

Defect. Winnebago Industries, Inc. (Winnebago) is recalling certain 2012-2018 Winnebago ERA motorhomes. The overhead cabinet shelf may have been improperly attached, allowing the cabinet face to detach and fall into the cab area.

Risk. If the cabinet shelf detaches, contents from the cabinet may hit and/or distract the driver, increasing the risk of injury or a crash.

Remedy. Winnebago will notify owners, and dealers will install two support brackets, additional screws, and a maximum capacity warning label, free of charge. The recall began February 27, 2019. Owners may contact Winnebago customer service at 1-641-585-6939 or 1-800-537-1885.

Defect. Winnebago Industries, Inc. (Winnebago) 2012-2013 Winnebago Era, View, and Via motorhomes and Itasca Navion and Reyo motorhomes. The high pressure liquid propane hoses may harden at the crimp fitting, possibly resulting in a propane leak.

Risk. A propane leak in the presence of an ignition source can increase the risk of a fire.

Remedy. Winnebago will notify owners, and dealers will inspect the propane hose, replacing it as necessary, free of charge. The recall began September 17, 2018. Owners may contact Winnebago customer service at 1-641-585-6939 or 1-800-537-1885. Winnebago's number for this recall is 151.

Defect. Winnebago Industries, Inc. (Winnebago) is recalling certain 2013-2018 Winnebago Era, Travato, Minnie Winnie, Fuse, View, Trend, Aspect, Brave, Vista, Sightseer, Adventurer, Forza, Journey, Tour, Revel, Paseo, Chalet, Access, and Intent motorhomes and Commercial vehicles, and 2013-2018 Itasca Spirit, Navion, Cambria, Tribute, Sunstar, Sunova, Suncruiser, Solei, Meridian, Elipse, Horizon, Reyo, and Via motorhomes. These vehicles are equipped with Kidde Plastic-Handle or Push Button 'Pindicator' fire extinguishers that may become clogged, preventing the extinguisher from discharging as expected or excessive force may be needed to activate the extinguisher. Additionally, in certain models, the nozzle may detach from the valve assembly with enough force that it could cause injury and also render the product inoperable. For a full list of the affected fire extinguisher models visit: https://static.nhtsa.gov/odi/rcl/2017/RMISC-17E062-5427.pdf

Risk. In the event of a fire, if the fire extinguisher does not function properly, it can increase the risk of injury.

Remedy. Winnebago will notify owners, instructing them to contact Kidde for replacement or aftermarket fire extinguishers, free of charge. The recall began on January 19, 2018. Owners may contact Winnebago customer service at 1-641-585-3535, or Kidde customer service toll-free at 1-855-262-3540, or online at www.kidde.com and click on "Product Safety Recall" for more information.

Defect. Winnebago Industries, Inc. (Winnebago) is recalling certain model year 2013-2016 Winnebago Era, Travato, View, Trend, Via, Journey, and Tour motorhomes and Itasca Navion, Viva, Reyo, Meridian, and Elipse motorhomes manufactured June 26, 2012, to August 26, 2015. In the affected vehicles, the high pressure liquid propane (LP) hose may harden and result in an LP leak at the crimp fitting.

Risk. An LP leak in the presence of an ignition source increases the risk of a fire.

Remedy. Winnebago will notify owners, and dealers will replace the LP hose, free of charge. The recall began on November 25, 2015. Owners may contact Winnebago customer service at 1-641-585-3535.

Defect. Winnebago Industries, Inc. (Winnebago) is recalling certain model year 2012-2016 Winnebago Era recreational vehicles manufactured November 11, 2010, to July 20, 2015. The certification label affixed to the vehicles provide an incorrect front tire inflation pressure. Accordingly, these vehicles fail to comply with the requirements of 49 CFR Part 567, "Certification."

Risk. Incorrect tire pressure information could cause an owner or operator to under or over inflate the tires, increasing the risk of a tire failure and a crash.

Remedy. Winnebago will notify owners, and dealers will provide new certification labels with the correct tire inflation pressure specifications, free of charge. The recall began on September 18, 2015. Owners may contact Winnebago customer service at 1-641-585-3535.

Defect. Winnebago is recalling certain model year 2009-2013 model Era motorhomes, 2010-2013 Via and Itasca Reyo motorhomes, and 2011-2013 View and Itasca Navion motorhomes; manufactured November 13, 2007, through August 20, 2012. The proper fuses were not installed for the refrigerator circuits.

Risk. Without the proper fuse, heat can build which could lead to a vehicle fire.

Remedy. Winnebago will notify owners, and dealers will replace the fuses. The recall began on December 21, 2012. Consumers may contact Winnebago Industries owner relations at 1-641-585-6939.

THE VEHICLE DOES NOT HAVE A "TIRE PRESSURE MONITORING SYSTEM". I RECENTLY PURCHASED A NEW DUAL-WHEELED-AXLE (I.E., 4 WHEELS ON ONE AXLE) RECREATIONAL VEHICLE (RV) THAT WAS MANUFACTURED IN TWO STAGES BY TWO SEPARATE WELL KNOWN MANUFACTURERS. THE CHASSIS WAS MANUFACTURED BY MERCEDES-BENZ AS A MODEL SPRINTER 3500 HAVING A 11,030 LBS GVWR. THE SECOND MANUFACTURER WAS WINNEBAGO WHO MODIFIED THE CHASSIS TO EQUIP THE UNIT AS THEIR 2013 WINNEBAGO MODEL ERA 170A CLASS B RV. I PURCHASED THE NEW 2013 WINNEBAGO ERA 170A FROM A SELLER OF NEW WINNEBAGO RVS. THE CHASSIS MANUAL AND VEHICLE PLACARD STATES THAT IT IS DESIGNED FOR A GVWR OF 11,030 POUNDS. THE RV, AS OUTFITTED WITH THE FULL WEIGHT OF FLUIDS AND TWO PASSENGERS, HAS A CERTIFIED WEIGHT OF 9,280 POUNDS (3,760 LBS STEERABLE AXLE AND 5,520 LBS REAR AXLE). IF LOADED WITH ANOTHER 720 POUNDS OF CARGO, NOT LIKELY, THE RV WOULD MEET THE 10,000 POUND VALUE IN 49 CFR 571.138; TIRE PRESSURE MONITORING SYSTEMS. IT WOULD REQUIRE LOADING THE RV WITH 1,750 POUNDS TO ATTAIN THE GVWR OF 11,030 POUNDS ? EVEN MORE UNLIKELY UNDER MY OWNERSHIP. MUST THIS VEHICLE BE SOLD WITH A ?TIRE PRESSURE MONITORING SYSTEM? TO BE IN COMPLIANCE WITH 49 CFR 571.138? I AM CONFUSED BY THE S2 EXCEPTION STATEMENT IN, 571.138 STANDARD NO. 138; TIRE PRESSURE MONITORING SYSTEMS. S1. PURPOSE AND SCOPE. THIS STANDARD SPECIFIES PERFORMANCE REQUIREMENTS FOR TIRE PRESSURE MONITORING SYSTEMS TO PREVENT SIGNIFICANT UNDER-INFLATION OF TIRES AND THE RESULTING SAFETY PROBLEMS. S2. APP