Pierce Manufacturing: Power Train › Axle Assembly › Axle Shaft
Pierce Manufacturing reported this defect to federal regulators on May 30, 2017 and put the number of vehicles at risk at 225. The repair is free for as long as the recall stands.
The defect
Pierce Manufacturing (Pierce) is recalling certain 1999-2013 Arrow XT, Dash, Enforcer, Quantum and Velocity fire trucks equipped with the electric All-steer rear steering option. The affected vehicles have rear steer axle shafts that were not properly heat treated.
The risk
Axle shafts that are not properly heat treated may break and potentially disable the vehicle, increasing the risk of a crash.
The remedy
Pierce will notify owners, and dealers will replace the rear steer axle shafts, free of charge. An interim notice was mailed on July 24, 2017. The recall began June 3, 2020. Owners may contact Pierce customer service at 1-888-974-3723.
75 model years covered
Newest firstWhat this page is, and what to do next
A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.
This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 17V348000.
Full record for the 2013 Pierce Arrow XT → · Recalls carrying a do-not-drive advisory → · Where this data comes from →