Altec Industries, Inc.: Equipment › Mechanical › Boom/Crane/Ladder › Controls/Control Wiring
Altec Industries, Inc. reported this defect to federal regulators on May 15, 2026 and put the number of vehicles at risk at 213. The repair is free for as long as the recall stands.
The defect
Altec Industries, Inc. (Altec) is recalling certain 2022-2025 AT Series, 2021-2025 AN Series Aerial Device, 2020-2026 TA Series Aerial Device, 2021 L Series Aerial Device, 2021 LR Series Aerial Device, 2023-2025 AM Series Aerial Device, and 2024-2025 AA Series Aerial Device vehicles. The ground level emergency stop (E-stop) may not stop hydraulic functions of the machine when the machine is in ePTO mode.
The risk
Hydraulic functions that do not immediately stop when the ground level E-stop is pressed, increase the risk of injury.
The remedy
Altec will inspect the units and test to verify the E-stop function. If the wiring is found to be incorrect, it will be updated, free of charge. Owner notification letters were mailed October 12, 2026. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN-3322.
23 model years covered
Newest firstWhat this page is, and what to do next
A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.
This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 26V310000.
Full record for the 2026 Altec TA Series Aerial Device → · Recalls carrying a do-not-drive advisory → · Where this data comes from →