2000 Daewoo Nubira

Defect. ON CERTAIN PASSENGER VEHICLES, THE CAMSHAFT POSITION SENSOR MAY MELT RESULTING IN A BURNING SMELL AND VISIBLE SMOKE, WHICH MAY SUBSEQUENTLY LEAD TO THE MELTING OF THE CAMSHAFT COVER AND THE CAMSHAFT POSITION SENSOR WIRE HARNESS.

Risk. THIS COULD POSSIBLY CAUSE AN UNDERHOOD FIRE.

Remedy. DEALERS WILL REPLACE THE CAMSHAFT POSITION SENSORS AND INSTALL AN ADDITIONAL FUSE. OWNERS SHOULD CONTACT DAEWOO PUERTO RICO AT 1-877-362-1234 OPTION 6.

Defect. ON CERTAIN PASSENGER VEHICLES, THE CAMSHAFT POSITION SENSOR MAY MELT RESULTING IN A BURNING SMELL AND VISIBLE SMOKE, WHICH MAY SUBSEQUENTLY LEAD TO THE MELTING OF THE CAMSHAFT COVER AND THE CAMSHAFT POSITION SENSOR WIRE HARNESS.

Risk. THIS COULD POSSIBLY CAUSE AN UNDERHOOD FIRE.

Remedy. DEALERS WILL REPLACE THE CAMSHAFT POSITION SENSORS AND INSTALL AN ADDITIONAL FUSE. THE RECALL BEGAN ON SEPTEMBER 7, 2004. OWNERS SHOULD CONTACT DAEWOO AT 1-877-362-1234, OPTION 6, OR FIND A LOCAL DEALER THROUGH THEIR WEBSITE AT WWW.DAEWOOUS.COM.

Defect. CERTAIN PASSENGER VEHICLES FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 106, "BRAKE HOSES." A CRACK CAN DEVELOP IN THE OUTER RUBBER LAYER OF THE FRONT BRAKE HOSE(S).

Risk. THIS CAN RESULT IN BRAKE HOSE RUPTURE, BRAKE FLUID LEAKAGE, AND LOSS OF VEHICLE BRAKING.

Remedy. DEALERS WILL INSTALL NEW REDESIGNED FRONT BRAKE HOSES. OWNER NOTIFICATION BEGAN OCTOBER 27, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAEWOO AT 1-877-362-1234, SELECTION 1.

I PURCHASED THE VEHICLE IN 2009 IT PREVIOUSLY HAD TWO OWNERS. I'VE HAD MINOR REPAIRS DONE ALREADY. HOWEVER, I WAS CURIOUS TO KNOW WHY THE VEHICLE WAS RECALLED. AS I LOOKED INTO IT I FOUND THAT IM HAVING PROBLEMS WITH THE ENGINE SENSOR WHICH I HAD REPAIRED 2 MONTHS AGO BECAUSE THE CHECK ENGINE CAME ON BUT I KEEP SMELLING A BURNING SMELL AND VISIBLE SMOKE. *TR

TL*THE CONTACT OWNS A 2000 DAEWOO NUBIRA. ON DECEMBER 1, 2006, ALL FOUR TIRES ON THE VEHICLE WERE REPLACED WITH 2005 COOPER TIRES. THE CONTACT TOOK THE VEHICLE TO A LOCAL REPAIR SHOP TO HAVE HER TIRES ROTATED AND WAS INFORMED THAT THE TIRES WERE MANUFACTURED ON DECEMBER 1, 2005. SHE TOOK THE TIRES BACK TO WHERE SHE PURCHASED THEM AND WANTED NEW REPLACEMENT TIRES. THE TECHNICIAN INFORMED HER THAT THEY WERE REQUIRED BY LAW TO SELL TIRES THAT WERE A YEAR OLD. THE TIRE SIZE AND DOT NUMBER WERE UNKNOWN. THE CURRENT MILEAGE WAS 67,590 AND FAILURE MILEAGE WAS 57,232.

CAMSHAFT POSITION SENSOR NEEDS TO BE REPLACED FOR SECOND TIME. I HAD TO GET THE CAMSHAFT POSITION SENSOR REPLACED AT MY COST. SECOND TIME IT BURNT ONE OF THE FUSES OUT. I AM UNABLE TO PAY ANOTHER TIME FOR THIS RECALL. CONTACTED DAEWOO AT THE NUMBER PLACED ON YOUR WEBSITE. THEY TOLD ME TO CONTACT DEALERSHIP. DEALERSHIP REFUSED TO DO RECALL WORK UNLESS I PAID FOR LABOR AND PART FIRST AND THEN CONTACT DAEWOO FOR REIMBURSEMENT. I CANNOT GET MY TAGS WHICH I ALREADY PAID FOR BECAUSE CAR WILL NOT PASS SMOG. DMV GAVE ME ONE EXTENSION ALREADY. TRIED TO ORDER PART FROM SEVERAL DIFFERENT AUTO PARTS STORES. THEY STATED THIS PART IS ON BACK ORDER AND COULD TAKE ANYWHERE FROM TWO WEEKS TO TWO YEARS. QUALITY MOTOR SHOP STATED CAMSHAFT POSITION SENSOR WAS A RECALL ITEM. WHAT GOOD IS NHTSA IF YOU DO NOT ENFORCE DEALERSHIPS OR COMPANY TO HONOR RECALL WORK? *TR

2000 DAEWOO NUBIRA ELECTRICAL SYSTEM CAUGHT FIRE. CONSUMER WOULD LIKE COMPENSATION FOR THE UNDERHOOD FIRE. *KB A SHORT CIRCUIT WITHIN THE WIRING OF THE CAM SENSOR IGNITED WHICH RESULTED IN A FIRE. THE COMPONENT HAD BEEN RECALLED FOR SIMILAR MAKE/MODEL DAEWOO VEHICLES. THE CONSUMER'S VEHICLE WAS NOT INCLUDED IN THE RECALL. *NM CONSUMER SENT IN ADDITIONAL INFORMATION IN A VOQ. *KB UPDATED 04/14/08. *KB

CONSUMER WOULD LIKE REIMBURSEMENT FOR REPAIRS ON 2000 DAEWOO NUBIRA. *KB RECALL 04V357000. THE VALVE COVER GASKET WAS ALSO REPLACED. *JB

2000 DAEWOO NUBIRA VIN FALLS UNDER RECALL BUT THE PART NUMBER DOES NOT. MECHANIC INFORMED CONSUMER THAT HE WOULD BE RESPONSIBLE FOR PARTS AND LABOR FEE. *KB THE RECALL WAS FOR THE CAMSHAFT POSITION SENSOR. THE CHECK ENGINE LIGHT IN THE VEHICLE REMAINS ILLUMINATED AT ALL TIMES. THE DIAGNOSTIC SCANNER FOUND TROUBLE CODE P0304 WHICH SUGGEST CAMSHAFT POSITION SENSOR CIRCUIT MALFUNCTION. THE CONSUMER CALLED DAEWOO CUSTOMER SERVICE AND LEFT A MESSAGE BUT NO ONE HAS RETURNED THE CALL. *NM

CONSUMER RECEIVED A RECALL NOTICE FOR THE CAMSHAFT POSITION SENSOR. MECHANIC STATED THAT THE PART NUMBER DOES NOT FALL IN THE LIST TO BE REPLACED. *TS IF THE PART WAS REPLACED THE CONSUMER WOULD HAVE TO PAY OUT OF POCKET FOR THE RECALL REPAIRS (04V357000). THE VEHICLE'S CHECK ENGINE LIGHT ILLUMINATES AS DESCRIBED IN THE RECALL. THE CONSUMER CONTACTED DAEWOO CUSTOMER SERVICE AND HAS LET MESSAGES BUT NO ONE HAS CALLED BACK. *NM

RECEIVED A RECALL LETTER. FOUND A DAEWOO DEALER, TRAVELED 20 MILE'S, TOOK OFF FROM WORK. DEALER DIDN'T CHANGE THE PART, CAMSHAFT POSITION SENSOR. WANTED INSTEAD TO CHANGE HOSES AT MY EXPENSE. FELT UNCOMFORTABLE AND ANXIOUS AND IRRITATED. *JB

THE FRONT CONTROL ARM BUSHINGS WORE OUT AT 27, 000 MILES. AS A RESULT, WHEN APPLYING THE BRAKES A LOUD SQUEAKING NOISE WAS PRODUCED. *AK THE CONTROL ARM BUSHINGS WERE REPLACED. *SC *JB

DAEWOO NUBIRA WAGON CDX . MULTIPLE BRAKE PROBLEMS. HAD ROTORS TURNED 3 TIMES BEFORE WARRANTY RAN OUT. HAVE REPLACED ROTORS AND PADS. I WAS INFORMED BY A MECHANIC THAT THERE IS NO ADUSTING THE BACK BREAK CALLIPERS. MEANING THE BACK BRAKES DON'T WORK. BRAKE PETAL GOES TO THE FLOOR. SLIDES AT EVERY STOP.ABS HAS MULTIPLE TEETH BROKE. DEALER REFUSED TO FIX UNDER WARRANTY. CONTROL ARMS BAD. SERP BELT BAD.TIRES ALL REPLACED. I ONLY HAVE 32,000 MILES ON CAR. CAN'T GET COLLISION INSURANCE AT FAIR PRICE.

CONSUMER RECEIVED RECALL 04V357000 CONCERNING ENGINE AND ENGINE COOLING. CONSUMER TOOK VEHICLE TO THE DEALER FOR SERVICE, AND IT WAS EXPLAINED TO HER THAT THIS VEHICLE WAS NOT INCLUDED IN THE RECALL DUE TO VIN.*AK CONSUMER CONCERNED THAT THE CAR MAY CATCH ON FIRE IF CAMSHAFT IS NOT FIXED. THE CONSUMER PURCHASE THE PART BUT CANNOT AFFORD THE LABOR. THE CONSUMER REQUEST REIMBURSEMENT FOR PART. *BF *NM

'RECALL CAMPAIGN: CAM SHAFT POSITION SENSOR. *BF THE CONSUMER ATTEMPTED TO CONTACT THE MANUFACTURER IN REFERENCE TO THE CMP SENSOR. THE CONSUMER HAD TO TAKE THE VEHICLE TO AN INDEPENDENT REPAIR FACILITY TO HAVE THE RECALL WORK COMPLETED. THE CONSUMER REQUEST REIMBURSEMENT FOR THE REPAIR. *NM

THE CONSUMER RECEIVED, NHTSA RECALL CAMPAIGN LETTER #04V357000 REGARDING THE CAM SHAFT POSITION SENSOR. THE COMPANY WAS OUT BUSINESS. NO DEALERSHIP AVAILABLE. *JB *TC

CONSUMER RECALL 04V357000 CONCERNING CAM SHAFT POSITION SENSOR. IN SEPTEMBER, 2004. CONSUMER CONTACTED A DAEWOO DEALERSHIP, AND WAS TOLD THAT PARTS NEEDED FOR REPAIRS WERE UNAVAILABLE, AND THERE IS NO INDICATION AS TO WHEN THEY WILL BE AVAILABLE. ALSO, CONSUMER CONTACTED THE MANUFACTURER, BUT WAS UNABLE TO SPEAK TO ANY BODY IN PERSON. *AK...*AK

A RECALL(04V357000) FOR THE CAM SHAFT POSITION SENSOR WAS REPAIRED, HOWEVER THE PROBLEM STILL EXIST. THE DEALER HAS BEEN NOTIFIED, BUT STATES THERE IS NOTHING THEY CAN DO. PLEASE PROVIDE ADDITIONAL INFORMATION. *JB

THE DEALERSHIP WAS NOT ABLE TO PERFORM THE FMVSS106/BRAKE HOSE RECALL 02V257000 WITHIN A REASONABLE TIME FRAME. THEY TOLD THE CONSUMER TO BRING THE VEHICLE BACK IN DECEMBER ALTHOUGH THE SYMPTOMS OF THE RECALL HAD ALREADY STARTED TO OCCUR. *JB VEHICLE FUEL INJECTORS NOT WORKING RIGHT. GAS FUMES COMING THROUGH THE VENTS. BRAKE FLUID LEAKING FROM THE FRONT BRAKE BURNING SMELL FROM THE FRONT OF THE VEHICLE. TRANSMISSION NOT FUNCTIONING PROPERLY. THE CONSUMER HAD TO REPLACE THE RADIO DO TO ELECTRICAL PROBLEMS IN THE VEHICLE. *TC

THE CONSUMER RECEIVED RECALL 04V357000 CONCERNING CAM SHAFT POSITION SENSOR. TOOK VEHICLE TO A DAEWOO DEALERSHIP. 3 HOURS LATER SERVICE MANAGER WAS TOLD BY DAEWOO THAT THEY WERE INSTRUCTED TO INSPECT THE VEHICLE, BUT DID NOT PERFORM ANYTHING RELATING TO THE RECALL. THE CONSUMER WAS FURIOUS, AND FELT CHEATED BECAUSE NOTHING WAS DONE. *AK THE CHECK ENGINE LIGHT ILLUMINATED ON 10/11/03. THE CONSUMER WAS INFORMED THAT THE SENSOR HAD MALFUNCTIONED. THE CHECK ENGINE LIGHT WAS CURRENTLY ILLUMINATED. *SC *JB

DEALER REFUSED TO MAKE REPAIRS ON CONSUMERS VEHICLE SINCE THEY ALREADY MADE REPAIRS, AND HAD NOT BEEN REIMBURSED FOR NHTSA RECALL 04V357000 CONCERNING CAM SHAFT SENSOR. *AK

A RECALL 04V357000 WAS ISSUED FOR THE CAM SHAFT POSITION SENSOR. DEALER WAS REFUSING TO REPAIR THE VEHICLE BECAUSE THE PART SERIAL NUMBER WAS NOT INCLUDED. *AK THE CONSUMER REQUESTED REIMBURSEMENT. *SC

02 V 257 000/FMVSS 106/BRAKE HOSES: THE CONSUMER RECEIVED A RECALL NOTICE AND WAS UNABLE TO LOCATE A AUTHORIZED SERVICE CENTER WITHIN HIS AREA. *JB *TC