Terex South Dakota, Inc.: Equipment
Terex South Dakota, Inc. reported this defect to federal regulators on Mar 19, 2026 and put the number of vehicles at risk at 2,303. The repair is free for as long as the recall stands.
The defect
Terex South Dakota, Inc. (Terex) is recalling certain 2019-2026 General 65, General 80, General 95, C4000, C5000, and C6000 digger utility trucks equipped with pole guides. An insufficient weld on the plate weldment may crack, causing the retaining pin to separate.
The risk
Without a retaining pin, the pole guide arm may fall, increasing the risk of injury to people around the truck.
The remedy
Owners will inspect the plate weldment for any cracks or abnormal welds. Dealers or owners will replace the plate weldment as necessary, free of charge. Owner notification letters were mailed June 2, 2026. Owners may contact Terex's customer service at 1-605-882-4000. Terex's number for this recall is SN737.
48 model years covered
Newest firstWhat this page is, and what to do next
A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.
This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 26V167000.
Full record for the 2026 Terex C4000 → · Recalls carrying a do-not-drive advisory → · Where this data comes from →