Braun Ambulances: Electrical System › Wiring
Braun Ambulances reported this defect to federal regulators on Feb 1, 2024 and put the number of vehicles at risk at 628. The repair is free for as long as the recall stands.
The defect
Braun Ambulances (Braun) is recalling certain 2020-2023 Chief XL I, Express Plus I, Chief XL III, Liberty I, Super Chief I, Signature Series III, Signature Series I, and 2020-2024 Express III emergency vehicles equipped with Weldon 8X16 Input-Output nodes. In the event of a short circuit or wiring failure, the firmware in the node may fail to shut off the output pin, resulting in overloaded electrical circuits.
The risk
Overloaded electrical circuits can overheat, increasing the risk of fire.
The remedy
Weldon will update the firmware, free of charge. Owner notification letters were mailed February 28, 2024. Owners may contact Akron Brass customer service at 1-800-228-1161 or Braun customer service at 1-800-488-0359. Braun's number for this recall is 2024-01.
33 model years covered
Newest firstWhat this page is, and what to do next
A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.
This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 24V063000.
Full record for the 2024 Braun Ambulances Express Type Iii → · Recalls carrying a do-not-drive advisory → · Where this data comes from →