NHTSA campaign 22V349000 · Part 573 safety recall report

Altec Industries, Inc.: Equipment › Mechanical › Boom/Crane/Ladder › Controls/Control Wiring

Altec Industries, Inc. reported this defect to federal regulators on May 18, 2022 and put the number of vehicles at risk at 477. The repair is free for as long as the recall stands.

The defect

Altec Industries, Inc. (Altec) is recalling certain 2016-2022 E-series & DH-H series Digger Derricks. The relay connectors may have been reattached to the incorrect plug after a stability test was performed. If the connections are not correct, the hydraulic overload protection system will not function.

The risk

A nonfunctional overload protection system may result in the operator unknowingly overloading the system, increasing the risk of injury.

The remedy

Altec will inspect and reattach the connectors, if necessary, free of charge. Owner notification letters were mailed on June 29, 2022. Owners may contact Altec's customer service at 1-877-462-5832. Altec's number for this recall is CSN 858.

What this page is, and what to do next

A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.

This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 22V349000.

Full record for the 2022 Altec Digger Derrick → · Recalls carrying a do-not-drive advisory → · Where this data comes from →