NHTSA campaign 21V998000 · Part 573 safety recall report

Altec Industries, Inc.: Equipment › Mechanical › Boom/Crane/Ladder › Motor/Hydraulic Pump

Altec Industries, Inc. reported this defect to federal regulators on Dec 20, 2021 and put the number of vehicles at risk at 150. The repair is free for as long as the recall stands.

The defect

Altec Industries, Inc. (Altec) is recalling certain 2017-2021 AN67-E100, AA67-E100, AN67, AA67, and AN55-E88 aerial devices. The hydraulic plumbing to the lift cylinders of the lower and upper booms could be connected incorrectly, allowing the boom to overextend.

The risk

The operator could overextend the boom while using the material handling jib, causing the aerial device to tip over and increasing the risk of injury.

The remedy

Altec will inspect and correct the plumbing as necessary, free of charge. Owner notification letters are expected to be mailed February 18, 2022. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 842.

5 model years covered

Newest first

What this page is, and what to do next

A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.

This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 21V998000.

Full record for the 2021 Altec Aerial Device → · Recalls carrying a do-not-drive advisory → · Where this data comes from →