NHTSA campaign 21V222000 · Part 573 safety recall report

Pierce Manufacturing: Exterior Lighting › Tail Lights

Pierce Manufacturing reported this defect to federal regulators on Mar 30, 2021 and put the number of vehicles at risk at 4. The repair is free for as long as the recall stands.

The defect

Pierce Manufacturing (Pierce) is recalling certain 2016-2018 Enforcer, Freightliner and Saber vehicles equipped with ECCO Holdings Code 3 7x9 Stop-Tail-Turn Reverse All-in-One LED stop, tail, turn, and reverse lights. The rear LED lights may be too bright. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 108, "Lamps, Reflective Devices, and Associated Equipment."

The risk

The excessive brightness may negatively affect the vision of other drivers, increasing the risk of a crash.

The remedy

Pierce will notify owners, and dealers will provide a filter kit to be installed in the rear lights, free of charge. The recall is expected to begin April 26, 2021. Owners may contact Pierce customer service at 1-888-974-3723.

What this page is, and what to do next

A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.

This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 21V222000.

Full record for the 2018 Pierce Enforcer → · Recalls carrying a do-not-drive advisory → · Where this data comes from →