Altec Industries Inc.: Equipment
Altec Industries Inc. reported this defect to federal regulators on Aug 5, 2019 and put the number of vehicles at risk at 32. The repair is free for as long as the recall stands.
The defect
Altec Industries Inc. (Altec) is recalling certain 2017-2019 LS60 Aerial Devices. The aerial devices may not meet all aerial level ground and slope stability requirements, allowing the units to become unstable and possibly overturn.
The risk
An unstable aerial device can increase the risk of injury.
The remedy
Altec will notify owners, instructing them to replace the unit load charts, adjust the Hydraulic Overload Protection (HOP) settings, verify the unit has the proper counterweight, and perform a stability test. The recall began September 13, 2019. Owners may contact Altec customer service at 1-877-462-5832.
4 model years covered
Newest first| Vehicle | Complaints | Recalls | Fires | Crashes |
|---|---|---|---|---|
| 2019 Altec Aerial Device | 0 | 29 | 0 | 0 |
| 2018 Altec Aerial Device | 0 | 36 | 0 | 0 |
| 2017 Altec Aerial Device | 0 | 38 | 0 | 0 |
| 2016 Altec Aerial Device | 0 | 26 | 0 | 0 |
What this page is, and what to do next
A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.
This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 19V573000.
Full record for the 2019 Altec Aerial Device → · Recalls carrying a do-not-drive advisory → · Where this data comes from →