Trails West Manufacturing Of Idaho, Inc.: Suspension › Rear › Axle › Non-powered Axle Assembly
Trails West Manufacturing Of Idaho, Inc. reported this defect to federal regulators on Nov 13, 2015 and put the number of vehicles at risk at 279. The repair is free for as long as the recall stands.
The defect
Trails West Manufacturing of Idaho, Inc. (Trails West) is recalling certain model year 2015-2016 Santa Fe, Santa Fe II, Classic, Classic II, Sierra, Sierra II, Royale, Sierra Select, RPM BP, and Hot Shot trailers manufactured February 18, 2015, to August 25, 2015, and equipped with 3500lb-capacity torsion model axles. The weld that secures the torsion arm assembly may fail allowing the tire, wheel, hub, and torsion arm to separate from the trailer.
The risk
A separation of the torsion arm can result in a reduction in vehicle stability, increasing the risk of a crash.
The remedy
Trails West will notify owners, and dealers will replace any suspect axles, free of charge. The recall began on December 9, 2015. Owners may contact Trails West customer service at 1-208-852-2200.
16 model years covered
Newest firstWhat this page is, and what to do next
A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.
This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 15V753000.
Full record for the 2016 Trails West Classic → · Recalls carrying a do-not-drive advisory → · Where this data comes from →