NHTSA campaign 99V014002 · Part 573 safety recall report

International Truck and Engine: Suspension › Front › Wheel Bearing

International Truck and Engine reported this defect to federal regulators on Mar 15, 1999 and put the number of vehicles at risk at 4,024. The repair is free for as long as the recall stands.

The defect

VEHICLE DESCRIPTION: CLASS 8 HEAVY DUTY TRUCK CHASSIS EQUIPPED WITH 16,000 LB., 18,000 LB., OR 20,000 LB. HEAVY DUTY STEERING AXLES. THE INNER WHEEL BEARING CONE FOR THE STEERING AXLE WHEEL HUB ASSEMBLY DOES NOT PROPERLY FIT ONTO THE NAVISTAR STEERING AXLE SPINDLE ASSEMBLY. IMPROPER FIT OF THE BEARING TO THE SPINDLE INCREASES THE STRESS LEVELS TO THE STEERING AXLE SPINDLE WHICH COULD CAUSE SPINDLE FAILURE.

The risk

IF THE SPINDLE FAILS, A LOSS OF DRIVER CONTROL COULD OCCUR, INCREASING THE RISK OF A VEHICLE CRASH.

The remedy

DEALERS WILL REMOVE THE LEFT AND RIGHT HUB/DRUM ASSEMBLIES FROM THE STEERING AXLES AND REPLACE THE INNER WHEEL BEARING CONES AND CUPS.

What this page is, and what to do next

A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.

This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 99V014002.

Full record for the 1999 Navistar 2500 → · Recalls carrying a do-not-drive advisory → · Where this data comes from →