Terex Advance Mixer, Inc.: Power Train › Axle Assembly › Axle Shaft
Terex Advance Mixer, Inc. reported this defect to federal regulators on Jan 17, 2020 and put the number of vehicles at risk at 34. The repair is free for as long as the recall stands.
The defect
Terex Advance Mixer (Terex) is recalling certain 2020 FDC300, FD4000, FD5000GL, and FD7000B vehicles. The axle output shafts were incorrectly heat treated, possibly causing them to fracture.
The risk
The fracturing of the output shaft would result in a loss of drive, increasing the risk of a crash.
The remedy
Terex has notified owners. Owners should inspect the Dana output flange for its production date. Dana will replace any that are in the affected range, free of charge. The recall began January 24, 2020. Owners may contact Terex customer service at 1-800-678-5961.
4 model years covered
Newest first| Vehicle | Complaints | Recalls | Fires | Crashes |
|---|---|---|---|---|
| 2020 Terex Advance FD4000 | 0 | 1 | 0 | 0 |
| 2020 Terex Advance FD5000GL | 0 | 1 | 0 | 0 |
| 2020 Terex Advance FD7000B | 0 | 1 | 0 | 0 |
| 2020 Terex Advance FDC300 | 0 | 1 | 0 | 0 |
What this page is, and what to do next
A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.
This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 20V023000.
Full record for the 2020 Terex Advance FD4000 → · Recalls carrying a do-not-drive advisory → · Where this data comes from →