NHTSA campaign 19V365000 · Part 573 safety recall report

Altec Industries Inc.: Equipment › Other › Labels

Altec Industries Inc. reported this defect to federal regulators on May 13, 2019 and put the number of vehicles at risk at 1,036. The repair is free for as long as the recall stands.

The defect

Altec Industries Inc. (Altec) is recalling certain 2009-2019 DL/DM, DL/DMB, DH, D/2/3/4, and DC Digger Derrick vehicles. The slope indicator placard card may falsely indicate that the unit could be used without leveling on a 5 degree slope.

The risk

An operator may improperly set up the unit, making the unit unstable, thus increasing the risk of injury.

The remedy

Altec will notify owners, and issue CSN 719 to owners, instructing them to remove the incorrect placards, free of charge. The recall began July 2, 2019. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 719.

What this page is, and what to do next

A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.

This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 19V365000.

Full record for the 2019 Altec Digger Derrick → · Recalls carrying a do-not-drive advisory → · Where this data comes from →