NHTSA campaign 18V791000 · Part 573 safety recall report

Altec Industries Inc.: Electrical System › Wiring › Fuses and Circuit Breakers

Altec Industries Inc. reported this defect to federal regulators on Nov 9, 2018 and put the number of vehicles at risk at 331. The repair is free for as long as the recall stands.

The defect

Altec Industries, Inc. (Altec) is recalling certain 2008-2018 Altec AC18, AC23, AC26, AC30 and AC38 Cranes and D2B, D3A, D4A/B, DL42B, DT65 and DT80 Digger Derrick vehicles. The wiring on the 12V circuit from the chassis battery to the Power Distribution Module (PDM) may be insufficiently sized.

The risk

The insufficiently sized wire may overheat, increasing the risk of fire.

The remedy

Altec will notify owners, and dealers will replace the wiring to the PDM, with a larger wire and/or replace the circuit breaker, free of charge. The recall began January 9, 2019. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN 703.

What this page is, and what to do next

A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.

This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 18V791000.

Full record for the 2018 Altec Crane → · Recalls carrying a do-not-drive advisory → · Where this data comes from →