NHTSA campaign 18V520000 · Part 573 safety recall report

Terex South Dakota, Inc.: Equipment

Terex South Dakota, Inc. reported this defect to federal regulators on Aug 7, 2018 and put the number of vehicles at risk at 101. The repair is free for as long as the recall stands.

The defect

Terex south Dakota, Inc. (Terex) is recalling certain 2015-2018 Terex C4000, C5000, C6000, and General digger derricks. The welds between the coupler and hex shaft may be undersized, causing them to fail and the auger to fall unexpectedly.

The risk

If the auger falls, it can increase the risk of injury to the user or bystanders.

The remedy

Terex will notify owners, and dealers will either repair the weld or replace the affected component, free of charge. The recall began October 3, 2018. Owners may contact Terex customer service at 1-605-882-4000. Terex's number for this recall is SN665.

What this page is, and what to do next

A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.

This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 18V520000.

Full record for the 2018 Terex C4000 → · Recalls carrying a do-not-drive advisory → · Where this data comes from →