NHTSA campaign 18V255000 · Part 573 safety recall report

Altec Industries Inc.: Structure

Altec Industries Inc. reported this defect to federal regulators on Apr 20, 2018 and put the number of vehicles at risk at 12. The repair is free for as long as the recall stands.

The defect

Altec Industries Inc. (Altec) is recalling certain 1992-2006 Digger Derrick trucks that have a specific boom pivot pin which may fail and cause the boom to move unexpectedly.

The risk

Unexpected boom movement can increase the risk of injury or death.

The remedy

Altec will notify owners and instruct them to inspect the vehicle for defective pivot pins and replace any that are found, free of charge. The recall began on May 22, 2018. Owners may contact Altec customer service at 1-877-462-5832.

What this page is, and what to do next

A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.

This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 18V255000.

Full record for the 2006 Altec Digger Derrick → · Recalls carrying a do-not-drive advisory → · Where this data comes from →