NHTSA campaign 17V709000 · Part 573 safety recall report

Altec Industries Inc.: Equipment › Mechanical

Altec Industries Inc. reported this defect to federal regulators on Nov 13, 2017 and put the number of vehicles at risk at 375. The repair is free for as long as the recall stands.

The defect

Altec Industries Inc. (Altec) is recalling certain 1992-2000 Aerial Cable Placer AP45 vehicles. The boom tips on these vehicles may crack and fail.

The risk

If the boom tip fails, it can increase the risk of injury.

The remedy

Altec will notify owners, and dealers will inspect the boom tip, replacing any that are of an old design or have cracks, free of charge. The recall began on December 7, 2017. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN655.

What this page is, and what to do next

A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.

This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 17V709000.

Full record for the 2000 Altec Aerial Cable Placer → · Recalls carrying a do-not-drive advisory → · Where this data comes from →