NHTSA campaign 12V456000 · Part 573 safety recall report

Altec Industries Inc.: Equipment

Altec Industries Inc. reported this defect to federal regulators on Sep 18, 2012 and put the number of vehicles at risk at 245. The repair is free for as long as the recall stands.

The defect

Altec Industries, Inc. is recalling certain model year 2002-2009 AH75/85/100 and HL125 aerial device vehicles equipped with 16-foot radial outriggers. An improper torque was applied to the outrigger cylinder piston retention system during assembly. As a result, the cylinder could loosen from the rod allowing the outrigger leg to protrude beyond the confines of the chassis when it is in a stowed position.

The risk

If the cylinder loosens from the rod, the outrigger could strike a person or object, increasing the risk of injury or property damage.

The remedy

Altec will notify owners, and will increase the torque on the piston free of charge. The safety recall began on November 6, 2012. Owners may contact Altec Industries at 1-877-462-5832.

What this page is, and what to do next

A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.

This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 12V456000.

Full record for the 2009 Altec AH100 → · Recalls carrying a do-not-drive advisory → · Where this data comes from →