NHTSA campaign 12V127000 · Part 573 safety recall report

Altec Industries Inc.: Equipment › Mechanical

Altec Industries Inc. reported this defect to federal regulators on Mar 26, 2012 and put the number of vehicles at risk at 1,222. The repair is free for as long as the recall stands.

The defect

ALTEC IS RECALLING CERTAIN MODEL YEAR 1993-2004 AA755 AND AA755L VEHICLES. CONTINUOUS OVERLOADING OR SIDE LOADING OF THE BOOMS COULD CAUSE THE LOWER BOOM TO CRACK NEAR THE LOWER BOOM PIVOT.

The risk

CONTINUED USE COULD CAUSE THE BOOM TO FAIL, INCREASING THE RISK OF INJURY TO PEOPLE OR PROPERTY BELOW.

The remedy

ALTEC WILL NOTIFY OWNERS, AND PROVIDE AA BOOM STIFFENER KIT. THE SAFETY RECALL BEGAN ON APRIL 20, 2012. OWNERS MAY CONTACT ALTEC AT 1-877-462-5832.

What this page is, and what to do next

A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.

This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 12V127000.

Full record for the 2004 Altec AA755 → · Recalls carrying a do-not-drive advisory → · Where this data comes from →