NHTSA campaign 09V149000 · Part 573 safety recall report

Terex Telelect, Inc.: Equipment

Terex Telelect, Inc. reported this defect to federal regulators on May 4, 2009 and put the number of vehicles at risk at 142. The repair is free for as long as the recall stands.

The defect

TEREX TELELECT, INC. IS RECALLING 142 MY 2008 C4000, C5000, C6000, C7000, AND GENERAL DIGGER DERRICK UTILITY TRUCKS MANUFACTURED BETWEEN SEPTEMBER 11 AND DECEMBER 20, 2008, EQUIPPED WITH EATON 25VQ HYDRAULIC PUMPS. POOR ADHESION OF THE BRONZE MATERIAL AND THE STEEL SURFACE OF THE FLEX PLATE USED IN THE 25VQ SECTION MAY LEAD TO DELAMINATION OF THE BRONZE FROM THE PLATE.

The risk

FAILURE OF THE PUMP WILL MAKE THE UNIT INOPERABLE AND POSSIBLY LEAVE THE OPERATOR OR LOAD SUSPENDED WHICH COULD RESULT IN PERSONAL INJURY OR DEATH.

The remedy

TEREX WILL NOTIFY OWNERS AND REPAIR THE VEHICLES FREE OF CHARGE. THE RECALL BEGAN ON JULY 31, 2009. OWNERS MAY CONTACT TEREX UTILITIES WARRANTY DEPARTMENT AT 1-605-884-3892.

5 model years covered

Newest first

What this page is, and what to do next

A recall is not an opinion. It is a Part 573 report a manufacturer is required by federal law to file once it decides a defect poses an unreasonable risk to safety, and it commits them to repairing the vehicle at no cost to the owner. The three passages above are the manufacturer’s own wording as published by NHTSA.

This page describes the campaign. It cannot tell you whether one particular car has already been through the shop — that is tracked by VIN, and only the manufacturer knows it. Check yours at nhtsa.gov/recalls or with a franchised dealer, quoting campaign number 09V149000.

Full record for the 2008 Terex C4000 → · Recalls carrying a do-not-drive advisory → · Where this data comes from →